Activating Safety Beam Mode - E.T. Systems DC BLUE ADVANCED Installer's Instructions

NB! When auto-close mode is activated, the safety beam mode automatically becomes active.
This is mandatory as auto-close mode may never be used without a set of safety beams installed.
With auto-close active, safety beam setup mode is no longer available in the setup menu.
To enter the Program
menu. Press and hold SET
button until buzzer beeps
twice.
Select safety beams
setup by scrolling up with
the UP button until "b"
flashes.
Press and release SET
button to enter safety
beam setup.
Press and release the UP
button for On or DOWN
button for Off selection.
Press and release the SET
button to save the new
setting to memory and
exit back to the main
program menu.
Scroll up or down
to next program
option.
ET DC BLUE ADVANCED INSTALLER 2012.025.12.05.2014

ACTIVATING SAFETY BEAM MODE.

Default – Off (Disabled)
From Standby Mode
Action
Display begins flashing
"P" and buzzer beeps
twice to confirm the
main program menu is
active.
Display flashes "b" to
confirm safety beam
setup mode is selected.
Buzzer beeps once and
current beam status is
displayed.
0 = Off and 1 = On
0 = Off (Disabled)
1 = On (Active)
The buzzer beeps once
and the display returns to
flashing "P".
Press and release EXIT to
OR
return to Standby mode.
16
www.et.co.za
Response
OR