Activating The Auto-Close Mode And Selecting An Auto-Close Time - E.T. Systems DC BLUE ADVANCED Installer's Instructions

ACTIVATING THE AUTO-CLOSE MODE AND SELECTING AN AUTO-CLOSE TIME.

NB! When auto-close mode is activated, the safety beam mode automatically becomes active.
This is mandatory as auto-close mode may never be used without a set of safety beams installed.
With auto-close active, safety beam setup mode is no longer available in the setup menu.
To enter the Program
menu. Press and hold SET
button until buzzer beeps
twice.
Select auto-close setup
by scrolling up with the
UP button until "A"
flashes.
Press and release SET
button to enter auto-
close setup.
Press and release the UP
or DOWN buttons to scroll
to the desired setting.
Press and release the SET
button to save the new
setting to memory and
exit back to the main
program menu.
Scroll up or down
to next program
option.
ET DC BLUE ADVANCED INSTALLER 2012.025.12.05.2014
From Standby Mode
Action
Default – Off
Display begins flashing
"P" and buzzer beeps
twice to confirm the
main program menu is
active.
Display flashes "A" to
confirm auto-close setup
mode is selected.
Buzzer beeps once and
current auto-close status
is displayed.
0 = Off. 5 = 50 sec.
1 = 10sec. 6 = 60sec.
2 = 20sec. 7 = 70sec.
3 = 30sec. 8 = 80sec.
4 = 40sec. 9 = 90sec.
The buzzer beeps once
and the display returns to
flashing "P".
Press and release EXIT to
OR
return to Standby mode.
17
www.et.co.za
Response
To