Battery Removal/Installation - Hitachi CL 10D Handling Instructions Manual

English
2. Cutter
Screw size
M10 × 1.5
M8 × 1.25
M6 × 1
W3/8" × 1.5875
3. Trimmer
Screw size
M10 × 1.5
M8 × 1.25
M6 × 1
M3/8" × 1.5875
Optional accessories are subject to change without notice.
APPLICATIONS
Cutting of soft steel studs

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Firmly support the power tool and remove the
battery while pushing the latch of the battery with
your thumb (Fig. 1).
CAUTION
Never short-circuit the battery.
Support the battery with your palm so that it does
not fall down.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 1)
Trigger
switch
Push
Latch
39
M10 Cutter ............................. 2
M10 Spacer ............................ 2
M8 Cutter ............................... 2
M8 Spacer .............................. 2
M6 Cutter ............................... 2
M6 Spacer ............................. 2
W3/8" Cutter ........................... 2
Handle
Insert
Pull out
Rechargeable battery
Fig. 1
Combining cutters and spacers
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Position the battery so that the nameplate faces
toward the caution plate of the charger and push
in the battery until it contacts the bottom plate. (See
Figs. 2 and 3.)
Rechargeable
battery
Rechargeable
battery
Insert
Latch
Nameplate
Fig. 2
Hole for connecting
the rechargeable
battery
Pilot lamp
Fig. 3