Specifications; Standard Accessories - Hitachi CL 10D Handling Instructions Manual

40°C. The most suitable temperature for charging
is that of 20 – 25°C.
11. Do not use the charger continuously.
When one charging is completed, leave the charger
for about 15 minutes before the next charging of
battery.
12. Do not charge the battery for more than 1 hour.
The battery will be fully charged in about 1 hour
and charging should be stopped when 1 hour has
elapsed from commencement. Disconnect the
charger power cord from the receptacle.
13. Do not allow foreign matter to enter the hole for
connecting the rechargeable battery.
14. Never disassemble the rechargeable battery and
charger.
15. Never short-circuit the rechargeable battery. Short-
circuiting the battery will cause a great electric

SPECIFICATIONS

POWER TOOL
Model
No-load speed
Capacity: Soft steel studs
(Size of screws for cutting)
Rechargeable battery (EB9)
Weight
CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

3
1 Charger (UC14YF or UC14YF2) .............................. 1
2 Plastic case ................................................................. 1
3 Hexagon bar wrench ................................................ 1
4 Cutter ........................................................................... 2
5 Trimmer ...................................................................... 1
The proper screw size for the accessory cutter 4 and
trimmer 5 are displayed on the packing box.
Standard accessories are subject to change without notice.
1
4
current and overheat. It results in burn or damage
to the battery.
16. Do not dispose of the battery in fire.
If the battery is burnt, it may explode.
17. When drilling in wall, floor or ceiling, check for
buried electric power cord, etc.
18. Bring the battery to the shop from which it was
purchased as soon as the post-charging battery
life becomes too short for practical use. Do not
dispose of the exhausted battery.
19. Using an exhausted battery will damage the
charger.
20. Do not insert object into the air ventilation slots
of the charger.
Inserting metal objects or inflammables into the
charger air ventilation slots will result in electrical
shock hazard or damaged charger.
CL10D
0 – 28/min
M10 × 1.5 M8 × 1.25
M3/8" × 1.5875
Ni-Cd battery, 9.6 V
3.4 kg
UC14YF / UC14YF2
7.2 – 14.4 V
1.3 kg
OPTIONAL ACCESSORIES (sold separately)
1. Battery (EB9, EB9B)
2
5
English
M6 × 1
38