Table of Contents
Advertisement
IRC-6 Infrared
Remote
Control
IRC-6 Operation
Page 16 of 21
The COLORband H9 USB is compatible with the IRC-6 infrared remote control from
Chauvet. To activate IR mode, follow the instructions below:
1.
Press <MENU> repeatedly until SET shows on the display.
2.
Press <ENTER> to accept.
3.
Press <UP> or <DOWN> to select ON or OFF.
4.
Press <ENTER>.
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1.
Press <AUTO> on the IRC-6.
2.
Press <+> or <–> to choose between the different auto programs.
To adjust the speed of the automatic program:
1.
Press <SPEED> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the speed of the program.
Sound-Active Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
Press <SOUND> on the IRC-6.
To adjust sound sensitivity in Sound-Active mode:
1.
Press <SENSITIVITY> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the sound sensitivity.
Manual Color Control
To choose a specific color with the IRC-6:
1.
Press <MANUAL> on the IRC-6.
2.
Press any number between <0>~<9> to choose your color.
To manually control the RGB percentage:
1.
Press <MANUAL> on the IRC-6.
2.
Press <R> (red), <G> (green), <B> (blue), <A> (amber), <UV>/<P> (UV), or
<W> (white) to choose your color.
3.
Press <+> or <–> to increase or decrease the percentage of each color.
Miscellaneous Operation
To adjust the total output level:
1.
Press <%> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the output level.
To adjust the strobe rate of the program:
1.
Press <STROBE> on the IRC-6.
2.
Press <+> or <–> to increase or decrease the strobe rate.
3.
Press <STROBE> again to turn off the strobe.
To select a fading program:
Press <FADE> on the IRC-6. Only P14 can be selected in this mode.
To black out the lights:
Press <BLACK OUT> on the IRC-6.
This will turn off all the lights until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
remote does not respond when a button is pressed, try pressing <BLACK OUT>. You
may have inadvertently activated Black Out.
COLORband H9 USB User Manual Rev. 2
Advertisement
Table of Contents
