Table of Contents
Advertisement
Configuration
(Standalone)
Automatic
Programs
Auto-Program
Speed
Sound-Active
Mode
Sound Sensitivity
Preset Color
Mode
Custom Color
Mixing
Dimmer Speed
COLORband H9 USB User Manual Rev. 2
Set the product in one of the standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To run the COLORband H9 USB in automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select an auto program (P1–14).
4.
Press <ENTER>.
To change the auto-program speed on the COLORband H9 USB, do the following:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> and <DOWN> to increase or decrease the program speed (S--1–100).
3.
Press <ENTER>. The product will return to the last selected mode.
To run the COLORband H9 USB in sound-active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To change the sound sensitivity on the COLORband H9 USB, follow the instructions
below:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Use <UP> and <DOWN> to increase or decrease the sound sensitivity (u--0–100).
3.
Press <ENTER>. The product will return to the last selected mode.
To run the COLORband H9 USB in preset color mode, follow the instructions below:
1.
Press <MENU> repeatedly until C-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select a static color (C1–63).
4.
Press <ENTER>.
To custom mix a static color, follow the instructions below:
1.
Press <MENU> repeatedly until U-- shows on the display.
2.
Press <ENTER> and one of the following will show on the display:
·
r_ _ _ (red)
·
g_ _ _ (green)
·
b_ _ _ (blue)
·
A_ _ _ (amber)
·
W_ _ _ (white)
·
P_ _ _ (UV)
3.
Press <ENTER> to cycle through the color settings.
4.
When the desired color shows on the display, use <UP> or <DOWN> to increase or
decrease the color value.
5.
Repeat steps 3 and 4 until the product outputs as desired.
To change dimmer speed on the COLORband H9 USB, do the following:
1.
Press <MENU> repeatedly until dIM shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select:
·
dIM1 (fast)
·
dIM2 (medium)
·
dIM3 (slow)
or
·
OFF.
4.
Press <ENTER>.
Page 15 of 21
Advertisement
Table of Contents
