Electronically published by Chauvet in the United States of America. CHAUVET, the Chauvet logo, and Hurricane Bubble Haze are registered trademarks or trademarks of Chauvet & Sons LLC (d/b/a Chauvet and Chauvet Lighting) in the United States and other countries. Other company and product names and logos referred to herein may be trademarks of their respective companies.
Keep this User Manual for future use. If the product is sold to someone else, be sure that they also receive this document. Page 2 of 13 Hurricane Bubble Haze User Manual Rev. 1...
Display Buttons In/Out Power Switch Fuse Holder Power Blower Bubble Fluid Haze Fluid Reservoir Reservoir Product Dimensions 15.5 in 394 mm 12.2 in 12.3 in 310 mm 312 mm Hurricane Bubble Haze User Manual Rev. 1 Page 3 of 13...
3. Setup AC Power The Hurricane Bubble Haze has a fixed voltage power supply and it can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific model. To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart.
Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes. Orientation The Hurricane Bubble Haze may be mounted in any position; however, make sure adequate ventilation is provided around the product. Rigging • Before deciding on a location, always make sure there is easy access to the product for maintenance and programming.
Use the Bubble Cleaning Mode after every use. Configuration (DMX) The Hurricane Bubble Haze works with a DMX controller. Information about DMX is in the CHAUVET DMX Primer, which is available from the Chauvet website http://www.chauvetlighting.com/downloads/ DMX_Primer_rev05_WO.pdf.
DMX signals from the controller. Bubble Output To turn the bubble output of the Hurricane Bubble Haze on or off, follow the instructions below. 1. Press <MENU> repeatedly until b shows on the display. 2. Press <ENTER>.
The Master/Slave mode allows a single Hurricane Bubble Haze product (the “master”) to control the actions of one or more Hurricane Bubble Haze products (the “slaves”) without the need of a DMX controller. The master product will be set to operate in standalone mode, while the slave products will be set to operate in Slave mode.
Thoroughly rinse the Bubble Fluid Reservoir. Restore the hoses and cap to the Bubble Fluid Reservoir. The Hurricane Bubble Haze may now be stored until its next use. NOTE: Use the Bubble Cleaning Mode after every use. Haze Fluid Reservoir...
Never operate the machine without fluid. Fog Cleaner Quart (FCQ) was specifically developed by Chauvet to clean your Hurricane Bubble Haze. Make sure you use FCQ regularly, no longer than 90 days between cleanings, to increase the life of your product.
Be sure to pack the product properly. Any shipping damage resulting from inadequate packaging will be your responsibility. FedEx packing or double-boxing are recommended. Chauvet reserves the right to use its own discretion to repair or replace returned product(s). Page 12 of 13 Hurricane Bubble Haze User Manual Rev. 1...
Visit the applicable website above to verify our contact information and instructions to request support. Outside the US, UK, Ireland, Mexico, France, Germany, or Benelux, contact the dealer of record. Hurricane Bubble Haze User Manual Rev. 1 Page 13 of 13...