Installing A Device On A Two-Post Rack - Extreme Networks ExtremeRouting SLX 9850-4 Hardware Installation Manual

9. Attach the device to the front (port side) posts of the four-post rack using 6 screws (3 on each side).
FIGURE 10 Attaching the device to the front posts of the rack
10. Install any device modules (management modules, switch fabric modules, interface modules, switch fabric modules, fan
modules, and power supply modules) that have not already been installed.

Installing a device on a two-post rack

Use part number XBR-SLX9850-4-2PRM-KIT to install the device on a two-post rack.
Verify that the items listed below are included in the rack kit.
ExtremeRouting SLX 9850-4 Hardware Installation Guide
9035474-02 Rev AA

Installing a device on a two-post rack

39