Table of Contents
Advertisement
Removing a DC power supply module
To remove a DC power supply, complete the following steps.
1.
If the device is operating and will continue to operate during the replacement, check the power LEDs to verify that the minimum
number of power supplies is functioning. Refer to the
check your power requirements.
2.
Disconnect the power supply from the power source.
3.
Use a #2 Phillips screwdriver to unscrew the power lugs.
FIGURE 55 DC power supply lugs
1.
Power lug
4.
Depress the latch on the lower part of the power supply to release the power supply from the chassis.
5.
Grasp the handle and pull, sliding the power supply from the chassis and supporting the power supply from beneath as you
remove it.
Inserting a DC power supply module
To insert a DC power supply module, complete the following steps.
1.
Unpack the new power supply and remove it from the anti-static bag.
2.
Inspect the power supply for damage.
3.
Insert the power supply into the slot.
ExtremeRouting SLX 9850-4 Hardware Installation Guide
9035474-02 Rev AA
ExtremeRouting SLX 9850 Technical Specifications
2.
Power lug
Inserting a DC power supply module
on page 137 to
109
Advertisement
Table of Contents
