Table of Contents
Advertisement
Required tools and equipment
CAUTION
To prevent damage to the chassis and components, never attempt to lift the chassis using the fan or power supply handles.
These handles were not designed to support the weight of the chassis.
Required tools and equipment
The following tools and equipment is required to install the SLX 9850:
•
#2 Phillips screwdriver
•
1/4" Hex socket driver
•
Pallet jack
•
Hydraulic lift or assisted lift, able to raise to a minimum of 140 cm (55 in.), with the ability to support the system weight
NOTE
The system weight varies depending on the type of system, and what modules are installed. To find the weight of your
device fully populated with the required interface modules, refer to the
Specifications
Device surface preparation
All surfaces on the Extreme device that are un-plated shall be brought to a bright finish and treated with an anti-oxidant solution before
connections are made.
All non-conductive surface on the Extreme device shall be removed from all threads and connection points to ensure electrical continuity.
Installing a device on a four-post rack
Use part number XBR-SLX9850-4-4PRM-KIT to install the device on a four-post rack.
Verify that the items listed below are included in the rack kit.
32
on page 137.
ExtremeRouting SLX 9850 Technical
ExtremeRouting SLX 9850-4 Hardware Installation Guide
9035474-02 Rev AA
Advertisement
Table of Contents
