Table of Contents
Advertisement
im Vertrieb von
HSA 800, 802, 822 Installation, cont'd
4.
Inside the bottom frame, identify the RJ-45 connector to be
replaced. With a tweeker, push down on and gently twist
on the front of the RJ-45 connector detent to disconnect the
connector from the bottom frame bezel plug-in.
5.
Note how the disconnected CAT 6 cable is routed inside
the HSA and then gently pull the cable free.
6.
Route the conversion kit telephone cable in the same
fashion as the removed CAT 6 cable.
7.
Snap the replacement RJ-11 connectors on the conversion
kit cable onto the interior of the AAP panel and lower
frame bezel plug-ins.
Reassembling the HSA
1.
Use tie wraps to bundle the CAT 6 and telephone cables
(figure 2-4). Use the impressions in the remaining CAT 6
cable of the tie wraps that you cut in Replacing the
connectors, step 2 on page 2-5 as a guide for placing the tie
wraps.
Figure 2-4 shows an HSA 802. For the purposes of this
procedure, the HSA 800 and HSA 822 are physically
similar.
Bundle the CAT 6 and telephone cables at the circled locations.
Figure 2-4 — Bundling interior cables
2.
Rest the AAP panels in place in the enclosure. Do not
secure the panels in place at this time.
www.camboard.de
2-6
RJ-45 to RJ-11 Conversion Kit • HSA 800, 802, 822 Installation
CAMBOARD Electronics
Tel. 07131 911201
RJ-45 to RJ-11 Conversion Kit • HSA 800, 802, 822 Installation
Fax 07131 911203
3.
Open and close the top panel while you experiment with
the routing of the cable bundle. Find a routing that allows
the top panel to open and close smoothly. If desired, use
tie wraps to secure the bundled cables to the tie-down
holes in the lower enclosure or on the mounting frame.
4.
Secure the two shroud halves to the enclosure frame with
the eight screws (four per side) removed in Replacing the
Connectors, step 1 on page 2-5.
5.
Replace the AAP panels in the surface mount enclosure
and secure them in place with the screws removed in
Removing the HSA from the Table, step 5 on page 2-5.
6.
Feed the cables connected to the AAPs in the HSA through
the hole in the table and connect them to the devices that
you disconnected them from in Removing the HSA from the
Table, step 3 on page 2-3.
7.
Carefully lower the HSA enclosure into the table opening.
From the underside, bolt the clamshell to the enclosure
with the two bolts removed in Removing the HSA from the
Table, step 4 on page 2-4.
8.
Connect the IEC power cord, the RJ-11, and RJ-45 cables to
the connectors on the underside of the surface mount
enclosure.
If desired, on the AAP panel, replace the connector icon by
9.
prying the old icon off of the bezel plug-in (figure 2-5)
with a tweeker and snapping a new icon in place. If
needed, four spare screws are stored in the underside of
the enclosure.
Icon Labels
Figure 2-5 — Changing the connector icon
10.
Open and close the top panel to check that the cables do
not interfere with smooth operation or rub against sharp
edges. If necessary, reach the cables through the cable
access holes in the lower frame and experiment with the
routing of the cable bundles. If desired, secure the cable
bundles on the mounting frame with tie wraps.
ce-info@camboard.de
2-7
Advertisement
Table of Contents
