Assembly; Operation - Husqvarna 525iHF3 Operator's Manual

Introduction
WARNING:
safety chapter before you assemble the
product.
To install the cutting unit
1. Loosen the screw on the cutting unit (A).
Introduction
WARNING:
safety chapter before you use the product.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note:
The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To charge the battery
Note:
Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2129 - 002 - 24.11.2023

Assembly

Read and understand the
B
C
A

Operation

Read and understand the
2. Put the shaft in the cutting unit. Align the screw (A)
with the hole in the shaft.
CAUTION:
shaft (C) engages with the gear in the
cutting unit.
3. Tighten the screw (A) with your fingers. Make sure
that screw (A) goes into the hole in the shaft.
4. Tighten the screw (A) fully.
5. Tighten the screw (B) fully.
2. Put the battery in the battery charger.
3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
Make sure that the drive
11