Preassemble The Short-Stroke Adapter - Siemens SIMATIC PRO Extension Units KP Series Operating Instructions Manual

Mounting and connecting the Extension Unit
3.2 Preparing the installation
Result
You need the following connecting cables, see "Rear" section in section
"Advanced operator controls and interfaces (Page 17)":
Number of slots in
between
0
1
4
-
3.2.5

Preassemble the short-stroke adapter

With some Advanced operator controls, a short-stroke adapter shortens the path of the lens
assemblies. Operation appears more precise and the reaction more immediate.
Preassemble the short-stroke adapter on the operator control.
Procedure
1. Install the spring to the left of the short-stroke adapter as shown.
2. Insert the short-stroke adapter into the operator control from behind. The short-stroke
adapter has a large and a small groove as locking element.
Make sure that the large groove on the short-stroke adapter engages in the large recess
on the operator control as marked.
3. Insert the short-stroke adapter into the operator control until it clicks into place. The short-
stroke adapter must grip the operator control evenly on all sides.
38
required cable lengths for skipping
50 mm connecting cable
105 mm connecting cable
300 mm connecting cable
500 mm connecting cable
Article number
6AV2185-8AW05-0AA0
6AV2185-8AW10-0AA0
6AV2185-8AW30-0AA0
6AV2185-8AW50-0AA0
Operating Instructions, 05/2019, A5E43600360-AC
Total
quantity
1
1
1
0
Extension Units KPxx