Technical Specifications; Certificates And Approvals - Siemens SIMATIC PRO Extension Units KP Series Operating Instructions Manual

Technical specifications

6.1

Certificates and approvals

ISO 9001 certificate
The Siemens quality management system for our entire product creation process
(development, production and sales) meets the requirements of ISO 9001:2008.
This has been certified by DQS (the German society for the certification of quality
management systems).
Certificate no.: 001323 QM08
Certifications and approvals for the Extension Unit and its installation elements can be found
on the Internet at the following address:
Extension Units certificates (https://support.industry.siemens.com/cs/ww/en/ps/24490/cert).
Approvals
Note
The following overview shows possible approvals.
For the device itself, only the approvals shown on the rear of the device apply.
CE approval
The device meets the general and safety-related requirements of the following EU directives
and conforms to the harmonized European standards for programmable logic controllers
published in the official gazettes of the European Union:
● 2014/30/EU "Electromagnetic Compatibility Directive" (EMC Directive)
● 2014/35/EU "Electrical equipment for use within specific voltage limits" (Low-Voltage
Directive)
● 2011/65/EU "Directive of the European Parliament and of the Council of 8 June 2011 on
the restriction of the use of certain hazardous substances in electrical and electronic
equipment" (RoHS Directive)
EU Declaration of Conformity
The EU Declarations of Conformity are available to the relevant authorities at the following
address:
Siemens AG
Digital Factory
Factory Automation
DF FA AS SYS
P.O. Box 1963
D-92209 Amberg, Germany
Extension Units KPxx
Operating Instructions, 05/2019, A5E43600360-AC
6
81