Siemens SIMATIC PRO Extension Units KP Series Operating Instructions Manual page 86

Technical specifications
6.4 Technical specifications
Degree of pollution / overvoltage category according to IEC 61131
● Degree of pollution 2
● Overvoltage category II
Power supply
Supply voltage (V
permitted range, low limit (DC)
permitted range, high limit (DC)
maximum permitted transients
Minimum time between two transients
Protection
Input current: Power consumption without load
Power consumption without load
Electrical isolation between different circuits
Reverse polarity protection
The power loss generally corresponds to the specified value for power consumption.
1
Power consumption with load: additional 0.1 W per operator control with LED.
2
Power consumption with load: additional 0.5 W per RGB illuminated pushbutton and 2.6 W per
3
KP12.
Maximum permissible terminal power rating (total power rating): 24 W.
Interfaces
X80 POWER, power supply
X10 EMERG, connection for emergency stop
button (output)
X11 LED, connection for LEDs of the operator
controls (input)
X12 CONTACT, connection for contacts of the
operator controls (output)
X1 PROFINET (LAN), 2 x RJ45 10/100Mbps *
* With integrated switch (one IP address only),
transmission mode 10BASE-T / 100BASE-TX, half / full duplex
86
)
N
1
Extension Unit Extension Unit PROFINET,
Hardwired Extension Unit PROFIsafe
24 V DC
19.2 V
28.8 V
35 V (500 ms)
50 s
7 A
24 V / 10 mA
0.24 W
2
No
Yes
Extension Unit Extension Unit
Hardwired PROFINET
yes yes
yes yes
yes no
yes no
no yes
Operating Instructions, 05/2019, A5E43600360-AC
4 A
24 V / 150 mA
3.6 W
3
Extension Unit
PROFIsafe
yes
no
no
no
yes
Extension Units KPxx