Installing The Reader - Siemens SIMATIC PRO Extension Units KP Series Operating Instructions Manual

Mounting and connecting the Extension Unit

3.8 Installing the reader

3.8 Installing the reader
NOTICE
Use only approved readers.
Readers that are not approved may damage the Extension Unit and the PRO device. Only
install readers with Siemens approval in the Extension Unit, see section
"Standard installation components (Page 18)".
Procedure
Note
Place the Extension Unit on a soft surface to avoid scratching the front.
The following description is based on the standard position of the Extension Unit, which
means as viewed from the inside with the cable harness below, the marking (
1. Cut out the foil on the inside of the Extension Unit along all cutouts required for the reader
with a sharp knife. Notice! Only cut within the cutouts.
2. Insert a screwdriver size 4 as shown in a gap of the screw bar and carefully lift out the
metal plate. If the metal plate does not release completely, use the screwdriver and insert
it into a different gap of the screw bar.
46
Operating Instructions, 05/2019, A5E43600360-AC
) above.
Extension Units KPxx