Maintenance; Vacuum Cleaner Storage; Replacing The Dust Bag - WERTHEIM 7 Series Instruction Manual

MAINTENANCE

Vacuum Cleaner Storage

When not in use, ensure that the cleaner is disconnected from the mains
power supply and that the cable is fully retracted. The combination floor
tool can be stored in the floor tool holders. Other floor tools must be stored
separately.

Replacing the Dust Bag

WARNING! Ensure that the cleaner is disconnected from the power supply
when installing or removing the dust bag.
Note: Only use the dust bag supplied or recommend by the manufacturer
to avoid causing damage to the machine and voiding the warranty.
14
Always operate the cleaner with the dust bag
installed. If you forget to install the dust bag or
the dust bag is installed incorrectly, the dust
bag cover may not close completely.
1. Remove the hose from the air inlet.
2. Open the cover by pulling on the Dust Bag
Cover Latch.
3. Remove the dust bag when it is full and
replace with a new dust bag.
4. Refit a new dust bag by inserting the dust
bag collar into the dust bag bracket. Ensure
that the arrow on the dust bag collar is
facing downwards when being inserted into
the dust bag bracket.
Note: The genuine Wertheim 7 Series dust bag
has been designed with a self closing seal to
prevent dust and debris from escaping when the
dust bag is removed from the cleaner.