Do you have a question about the Elegance Robot and is the answer not in the manual?
Questions and answers
Marion
April 11, 2025
Robot powers on and off again quickly, low battery, not charging and not connecting to wifi
1 comments:
Mr. Anderson
April 11, 2025
The WERTHEIM Elegance Robot may power on and off quickly and have a low battery because the battery requires recharging. It may not charge if the charging contacts are not properly aligned on the charging base. The indicator light should illuminate red while charging. For Wi-Fi issues, it may not connect if the wrong Wi-Fi password is used or if it is trying to connect to a 5GHz network instead of the required 2.4GHz Wi-Fi.
This answer is automatically generated
Manjula Raj
February 7, 2025
How to install Wertheim Elegance Robot app?
1 comments:
Mr. Anderson
February 10, 2025
To install the Wertheim Elegance Robot app, follow these steps:
1. Download the Wertheim Elegance Robot app from the appropriate app store. 2. Ensure your mobile device meets the minimum requirements: - iOS 9.0 or later - Android 5.0 or later 3. Connect the robot to Wi-Fi® by following the instructions in the app. - Note: The robot can only connect to a 2.4GHz Wi-Fi® router. 4. Use the app to monitor and control the robot from your smartphone or tablet.
Features Top Glass Cover Charger Adaptor On/Off Button 8. Side Brush Charging Base Bumper Recharge Button 10. Cliff Sensors Bumper Sensor Window 11. Charging Contacts Laser Distance Sensor 12. Roller Brush Accessories Included 2-in-1 Water Tank and Dust Bin Dry Dust Bin Mop Pads x 2 Remote Control Charging Base &...
INTRODUCTION Congratulations on the purchase of your new Wertheim Elegance Robot. There are many useful features built into your robot cleaner. We recommend that you carefully read this instruction manual to take the best advantage of these features. Specifications • Power: 48W •...
BEFORE YOU BEGIN This cleaner must be operated in accordance with these instructions and used only for domestic household cleaning to remove DRY dirt and dust from household carpets, hard floors. This cleaner is not fit to be used as an industrial cleaner and will void the manufacturer’s warranty if used inappropriately.
SAFETY INSTRUCTIONS IMPORTANT! Always switch off the cleaner before cleaning, when not in use or attempting any maintenance task. The charger must only be connected to an AC power supply at the voltage shown on the rating label. This cleaner should only be used for its intended purpose as described in this instruction manual.
Page 7
17. If the air inlet is blocked, switch off 23. Always store the appliance and the cleaner straight away. First, charger indoors in a cool and dry clear the blocked object before place. attempting to start the vacuum 24. Do not pick up water, for dry cleaner again.
The charger adapter contains council for instructions on how to electrical connections inside. safely dispose of the battery. The charger adapter is not a 10. Do not use the charger to charge serviceable part. a non-chargeable battery. 8. Before disposal of your battery, 11.
Page 9
1.5 meters away from stairs • Always keep the Charging Base plugged in and make sure it is in an area with consistent Wi-Fi coverage to allow the robot to receive ® information via the Wertheim Elegance Robot App.
Page 10
NOTE: When the robot completes the cleaning cycle or when battery power is low, the robot will automatically return to the Charging Base to recharge. Download the Wertheim Elegance Robot App and connect to the Wi-Fi by following the ®...
Page 11
Installing the 2-in-1 Water Tank and Dust Bin: Remove the Dry Dust Bin from the robot by pressing the Dust Bin Release button and gently pulling. Prepare the 2-in-1 Water Tank and Dust Bin. Ensure that a mop pad is installed onto the water tank as shown.
INSTRUCTIONS FOR USE IMPORTANT! Before commencing cleaning, please tidy up objects on the floor like cables, cleaning cloths, slippers and carpet with fringes to avoid the cleaner being tangled. On/Off Button Short press to start/pause cleaning cycle. Long press for 3 seconds to turn the robot on or off.
REMOTE CONTROL Return to the Start Auto Cleaning/Pause Charging Base/Pause Directional Arrows for Confirms Selection Manual Control Locate the Robot Power Level Water Flow Level Do Not Distrub On/Off Indicator Light On/Off Spot Cleaning...
Page 14
OPERATING THE WERTHEIM ELEGANCE ROBOT APP Press ‘Click to Add Device’ and follow the instructions in the App to connect the robot to your WiFi. Commands the robot to clean a particular area on the virtual map. Virtual Map. Commands the robot to clean a particular spot on the virtual map.
Page 15
Select ‘More’ on the App to access additional App functionality. Below are a few key features: To create a particular cleaning zone in your home, to command the robot to double clean a particular area or to prohibit the robot from cleaning a particular area.
MAINTENANCE IMPORTANT! Ensure that the cleaner is switched off before preforming any maintenance. Emptying the Dry Dust Bin Press the Dust Bin Release Button to remove the dust bin. To empty the dust bin, press the Dust Bin Lid Release Button, then open the dust bin lid, as shown.
Page 17
Cleaning & Replacing the Filters Open the dust bin lid and remove the filter assembly from the dust bin. Remove the filters and clean using the cleaning brush provided. Alternatively, replace the filters if required. NOTE: it is recommended to replace filters every 6 months.
TROUBLESHOOTING Servicing should be performed by an authorised service agent or qualified technician. Contact Wertheim Customer Service for your nearest authorised service agent on 1800 815 270 (AUS), 0800 282 288 (NZ). Problem Cause Solution The indicator light illuminates Place the robot onto the The robot cannot red.
Page 19
Electrical Home-Aids Pty. Limited. If Electrical Home-Aids Pty. Limited decide to repair or Your Wertheim cleaner, in the case of replace the cleaner, it will do so at its own domestic use, has a one year parts and cost.
Page 20
Electrical Home-Aids Pty. Limited ABN: 62 007 539 577 Level 1, Building 3, Brandon Business Park 530 Springvale Road, Glen Waverley, VIC, 3150 wertheimcleaning.com.au wertheim.co.nz enquiries@wertheim.net.au 11/20...
Need help?
Do you have a question about the Elegance Robot and is the answer not in the manual?
Questions and answers
Robot powers on and off again quickly, low battery, not charging and not connecting to wifi
The WERTHEIM Elegance Robot may power on and off quickly and have a low battery because the battery requires recharging. It may not charge if the charging contacts are not properly aligned on the charging base. The indicator light should illuminate red while charging. For Wi-Fi issues, it may not connect if the wrong Wi-Fi password is used or if it is trying to connect to a 5GHz network instead of the required 2.4GHz Wi-Fi.
This answer is automatically generated
How to install Wertheim Elegance Robot app?
To install the Wertheim Elegance Robot app, follow these steps:
1. Download the Wertheim Elegance Robot app from the appropriate app store.
2. Ensure your mobile device meets the minimum requirements:
- iOS 9.0 or later
- Android 5.0 or later
3. Connect the robot to Wi-Fi® by following the instructions in the app.
- Note: The robot can only connect to a 2.4GHz Wi-Fi® router.
4. Use the app to monitor and control the robot from your smartphone or tablet.
This answer is automatically generated
In anyone able to help me download the app please