Cleaning The Hard Floor Turbo Tool; Changing The Remote Control Battery - WERTHEIM 7 Series Instruction Manual

Cleaning the Hard Floor Turbo Tool

WARNING! Ensure that the cleaner is disconnected from the power
supply before performing any maintenance procedures.
LOCKING SWITCH

Changing the Remote Control Battery

WARNING! Ensure that the cleaner is disconnected from the power
supply before performing any maintenance procedures.
The rotating brush must be free of debris
for effective cleaning and for maximum
suction.
1. Disconnect the Hard Floor Turbo Tool
from the vacuum rod and turn it over to
inspect the rotating brush.
2. If a build-up of debris is wound around
the rotating brush, remove by carefully
cutting with scissors. Avoid damaging
or cutting the bristles.
To replace or clean the rotating brush, turn
the locking switch. The rotating brush can
now be replaced or cleaned.
1. Unscrew the battery holder with a
screwdriver. The battery holder can now
be pulled out from the handle.
2. Replace the battery and reinsert the battery
into the handle. Ensure the battery holder is
screwed securely with a screwdriver.
WARNING - Keep battery out of reach of children
and ensure the battery holder is secure. If you
suspect your child has swallowed or inserted
a button battery immediately call the 24-hour
Poisons Information Centre on 13 11 26 for fast,
expert advice.
19