Replacing The Powerhead Agitator Bar & Drive Belt - WERTHEIM 7 Series Instruction Manual

Replacing the Powerhead Agitator Bar & Drive Belt
WARNING! Ensure that the cleaner is disconnected from the power supply
and the powerhead is disconnected from the rod before performing any
maintenance procedures.
END CAP
18
Depending on frequency of use, the powerhead
agitator bar & drive belt will occasionally require
changing.
1. Disconnect the motorised powerhead from
the vacuum rod and turn it over. With a
Phillips head screwdriver unscrew the eight
screws, as shown.
2. Remove the powerhead cover to access the
agitator bar and belt.
3. Lift the side of the agitator bar with the belt
DRIVE attached and slide the belt off the end cap.
SHAFT
The agitator bar can now be removed for
cleaning or replacement.
4. Slide the belt off the drive shaft to remove
the belt. If the belt is broken, remove all the
broken pieces. To replace the belt, install
the new belt over the drive shaft first and
then the end cap. Make sure the lettering
on the belt is outward facing.
5. Reinstall the agitator bar securely back into
place. Then install the powerhead cover
and screws.