Canon imageCLASS MF269dw Service Manual page 268

■ SERIAL
COPIER (Service mode for printer) > OPTION (Specification setting mode) > SERIAL
SN-MAIN
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
Additional Functions
Mode
■ FNC-SW
COPIER (Service mode for printer) > OPTION (Specification setting mode) > FNC-SW
CRG-PROC
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
DRUM-PROC
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Write serial number
To write the serial number of this machine in the Main Controller PCB.
When executed, the half-size alphanumeric characters entered in [Location] of [Menu] are written
in the Main Controller PCB.
When replacing the Main Controller PCB, be sure to write the serial number in the new PBC to
prepare for trouble since the serial number of the device is not succeeded.
When replacing the Main Controller PCB.
1) Write down and keep the current data in [Location].
2) Turn OFF and then ON the main power.
3) Replace the Main Controller PCB.
4) Turn ON the main power.
5) Enter the serial number of this machine in [Location].
6) Execute this item.
7) Turn OFF and then ON the main power.
Once the serial number has been written in the Main Controller PCB, the data of [Location] will be
deleted.
8) Output the spec report by SPEC, and check that the entered serial number is registered.
9) Enter the data backed up in step 1 in [Location].
Since the above "Location" is only temporarily used to store data. Therefore back up the data
before input and enter it again after writing is completed.
COPIER > FUNCTION > MISC-P > OUTPUT > SPEC
RUI: Settings/Registration Menu: System Management Settings > Device Information Settings >
Location
LUI: Menu > System Manager Settings> Device Information Settings > Location
Set oprtn at toner ctrdg estd life reach
To set the operation of the machine when the parts counter of the toner cartridge reaches the
estimated life value.
Enter the setting value, and then press OK or Apply key.
0 to 2
0: Do not stop
1: Stop once
2: Stop completely
0
Set oprtn at drum ctrdge estd life reach
To set the operation of the machine when the parts counter of the drum cartridge reaches the
estimated life value.
Enter the setting value, and then press OK or Apply key.
0 to 2
0: Do not stop
1: Stop once
2: Stop completely
0
260
8. Service Mode