Canon imageCLASS MF269dw Service Manual page 257

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > ADJ-XY
ADJ-X-MG
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
■ CCD
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
W-PLT-X
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
W-PLT-Y
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
W-PLT-Z
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
FBTAR-R
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
FBTAR-G
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
FBTAR-B
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Fine adjust magnification: vertical scan
To adjust the magnification ratio by comparing the original and the copy output sheet.
- Increase the value when the output sheet is small.
- Decrease the value when the output sheet is large.
When the image on copy output sheet is larger or smaller than it is on the original
Enter the setting value, and then press OK or Apply key.
This adjustment is targeted to adjust the image position on copy output. This may affect the SCAN
image.
-30 to 30
0.1 %
0
Stdrd White Plt white lvl data (X) entry
To enter the Standard White Plate white level data (X)
Enter the setting value, and then press OK or Apply key.
7000 to 9999
8493
Stdrd White Plt white lvl data (Y) entry
To Enter the Standard White Plate white level data (Y)
Enter the setting value, and then press OK or Apply key.
7000 to 9999
8988
Stdrd White Plt white lvl data (Z) entry
To enter the Standard White Plate white level data (Z)
Enter the setting value, and then press OK or Apply key.
7000 to 9999
9176
Shading target value (R) entry
To enter the shading target value of RED at copyboard reading.
Enter the setting value, and then press OK or Apply key.
128 to 384
297
COPIER > DISPLAY > CCD > FB-TARGET-R
Shading target value (G) entry
To enter the shading target value of GREEN at copyboard reading.
Enter the setting value, and then press OK or Apply key.
128 to 384
294
COPIER > DISPLAY > CCD > FB-TARGET-G
Shading target value (B) entry
To enter the shading target value of BLUE at copyboard reading.
Enter the setting value, and then press OK or Apply key.
128 to 384
282
COPIER > DISPLAY > CCD > FB-TARGET-B
249
8. Service Mode