Galaxy Control Systems 635 Series Installation/Configuration Manual page 5

1.14 Network & IT Requirements for Galaxy Hardware
1.15 Communication Requirements for System Galaxy Servers
1.16 Requirements for Logins and User Privileges (SG Software)
1.17 Pinout for Ethernet Cable (Cat-5e)
1.18 General FAQs about Features of Galaxy Hardware
2. Hardware Installation Instructions
LIST OF TABLES IN THIS CHAPTER
LIST OF FIGURES FOUND IN THIS CHAPTER
STEP 1. Hardware Install ~ Site Preparation
1.1 Conducting a Site Survey................................................................................................................................... 2-5
Overall System Architecture:
Technical Certification:
Controller Power Supply and Power Sources:
1.2 Requirements and Safeguards .......................................................................................................................... 2-7
SAFEGUARDS:
REQUIREMENTS:
1.3 About Upgrading Hardware / Expanding Systems ............................................................................................. 2-9
WHEN IS UPGRADING THE HARDWARE REQUIRED?
WHEN IS UPGRADING THE SG SOFTWARE REQUIRED?
1.4 Board Compatibility and Capability (635 vs. 600 models) ................................................................................ 2-10
NOTES ABOUT REPAIR / MAINTENANCE / UPGRADE OF 600-MODEL CONTROLLERS
STEP 2. Mount the Controller Enclosure/Cabinet
2.1 Choose a good location for the Controller ....................................................................................................... 2-11
EXPOSURE
2.1.2 MOUNTING REQUIREMENTS
2.2 Running Field Wiring ........................................................................................................................................ 2-12
2.3 Mount the Controller Cabinet .......................................................................................................................... 2-13
STEP 3. Install Power Connectors inside Controller
3.1 Remove Heat Shrink (only from wires to be used) ........................................................................................... 2-14
3.2 Wire the CPU Power Connector and Tamper Switch ........................................................................................ 2-15
3.3 Wire the "A/C Fail" and "Low Battery" to Sense Connector ............................................................................. 2-16
3.4 Wire the Power Connectors for the Boards (DRM, DIO, or DSI) ........................................................................ 2-17
STEP 4. Install the CPU and Interface Boards (daughter boards)
4.1 Install the 635-CPU Board inside Controller ..................................................................................................... 2-18
4.2 Installing a 635-DRM Board (Dual Reader Module) .......................................................................................... 2-19
635-DRM - BOARD FEATURES
635-DRM - INSTALL REQUIREMENTS
635-DRM - BOARD INSTALLATION (STANDARD OPERATION)
PART 4.2.1 PRE-CONFIGURING THE SUPERVISION RESISTORS
PART 4.2.2 SETTING THE LOCK RELAY JUMPERS
PART 4.2.3 (REQUIRED) PRE-CONFIGURING THE BOARD ID
PART 4.2.4 (REQUIRED) INSTALLING THE 635 DRM BOARD IN THE CONTROLLER
4.3 Install the DIO Board in the Controller ............................................................................................................. 2-25
page ~ ii
1-29
1-30
1-31
1-31
1-32
2-1
2-2
2-3
2-5
2-5
2-5
2-5
2-7
2-8
2-9
2-9
2-10
2-11
2-11
2-11
2-14
2-18
2-19
2-20
2-21
2-21
2-22
2-23
2-24