Appendix H - HyperTerminal Commands
Setting Passwords and Encryption fields (optional):
TIP: If you want to keep the factory default settings, you can press the <Enter> key to
skip through these fields – options are explained below.
Setting a PASSWORD: (optional) used only for telnet; this is not needed for panel to
9.
communicate.
IMPORTANT: Also 'Allow Telnet' field must be set to "y" to enable telnet.
The default password is "install".
To keep/skip it -
To change it –
To erase it –
Setting a PASS PHRASE: (optional) - used for Event Encryption (next option); this not
10.
needed for panels to communicate). This is blank by default. Events will be encrypted
between the controller and Event Service if you set this up.
To keep or skip it -
To change it -
IMPORTANT: The 'ENCRYPT EVENTS' field must be set to "y" to enable feature.
IMPORTANT
Setting the ENCRYPT EVENTS (y/n): (optional – must have a pass phrase set (previous
11.
option) - this not needed for panels to communicate). This is 'n' (off) by default.
Type "y" or "n" to indicate yes (on) or no (off).
Event Server (in the Event Server - yes = checked; no = unchecked).
ALLOW TELNET: this option will block telnet capability if set to NO.
12.
IMPORTANT: The 'PASSWORD' field must also be set up (previous step).
600-SERIES HARDWARE MANUAL
Press <Enter> and advance to next field.
type a new password (4 to 8 characters) and press <Enter> key.
press the <space bar> then <Enter> to advance.
Press <Enter> and advance to next field.
type a new password (between 16 to 39 characters long).
: This value must match exactly to the pass phrase set in the Event Service.
APPENDIX-Page H-7
This must match the setting in the