Galaxy Control Systems 635 Series Installation/Configuration Manual page 160

Appendix H - HyperTerminal Commands
B. Programming the CPU Board
(Reference Chapter 1 for a consolidated list of IT Requirements).
IMPORTANT: See the Network Administrator to obtain network parameters. You
must use unique and valid ID's when programming a CPU.
Logging into Board's Config Mode:
IMPORTANT: You MUST type the all entries
1) Press the <Enter> key to get the login prompt if it is not displaying.
2) At the login, type "install" and press the <Enter> key.
3) At the ">" prompt, type "config" and press the <Enter> key.
A list of boards is displayed (only "known" boards that are physically connected
to the IC2 Bus will display). If this is a new install and you have not connected any
other boards, they will display after they are connected to Data Cable in a later step.
The CPU
shows up
as board 0
Type board
number "0"
to choose it.
600-SERIES HARDWARE MANUAL
in lowercase
In this example, you see the controller had 5 additional boards.
If you are doing a new install you will not see any boards that are
not connected, powered and given board ID's.
APPENDIX-Page H-3
.