Galaxy Control Systems 635 Series Installation/Configuration Manual page 162

Appendix H - HyperTerminal Commands
Setting the IP Address and Network Parameters:
NOTICE: Addressing must be set correctly or the board will not work.
See Network Administrator to get a valid IP Address, Network Mask and Gateway Address.
Set the IP Address and press <Enter> key:
3.
If a "static" address is used: This is usually obtained from a Network Administrator.
You must use a unique and conform to the Network guidelines
If DHCP addressing will be used: You can press <Enter> to skip this field as long as
it is already set to a non-zero address.
NOTICE: The 'DHCP Allowed' field must also be set to 'Y' in a following step.
After the CPU programming is saved and proper LAN connection is made, the CPU
will broadcast a request to obtain the DHCP address. The amount of time it takes to
receive the DHCP address is based on timing set in the DHCP server.
Set Network Mask and press <Enter> to advance:
4.
If a "static" address is used this must be set to a valid Network Mask.

If DHCP addressing used, you can skip this field, it is automatically assigned.

Set Gateway and press <Enter> to advance:
5.
If a "static" address is used this must be a valid Gateway if needed.

If DHCP addressing used, you can skip this field, it is automatically assigned.

600-SERIES HARDWARE MANUAL
(the following points are noted)
APPENDIX-Page H-5