Galaxy Control Systems 635 Series Installation/Configuration Manual page 169

Appendix I - How to find IP Address of Event Server
– Appendix : Finding IP Address of Event Server
I
 Go to the computer that runs the GCS Event Service. Open a DOS Command Window and
execute the ipconfig command at the prompt:
To open a DOS shell:
1. Click [Start] button on the
Windows® Task Bar
2. Select 'Run' option
3. Type "cmd" in the field
provided.
4. Click [OK] button (the DOS shell window will open).
5. Once the DOS Shell opens, type the ipconfig command in lower case. The screen will
display the IP Address of the Event Server.

The Event Server IP Address must be set in the controller's Event Server address field
(Chapter 2 Step-6 covers controller programming).

This Event Server IP Address must also be set in the SG Software Loop Properties
screen>Event Server address field (Appendix D ).

The Event Server listening port for TCP/IP Connection must use 4003
a. this is set in the Event Service (Chapter 3 Figure 35)
b. and also in the SG Software Loop Properties screen (Appendix D).

The Event Service Controller Communication port must use 3001
a. this is set in the Service (Chapter 3 Figure 34)
b. and in the controller's Event Server settings for local and remote ports (Ch 2 Step-6).
 You can use HyperTerminal to verify and change the Event Server parameters as needed -
Chapter 2 Step-6 covers how to connect with HyperTerminal and program the panel.
 You may be able to run a Web Browser to search for the panel by putting the Controller IP Address
into the browser Address field. You can view the Event Server settings (you cannot make changes
to the panel via the web browser). Note: the Allow Web Server must be on at the panel.
 If you cannot find the panel from a web browser, you can ping the panel from the Event Server.
(Appendix J covers pinging the controller from the Event Server.)
600-SERIES HARDWARE MANUAL
APPENDIX-Page I-1