Appendix H - HyperTerminal Commands
VERIFY BOARD IDS
From HyperTerminal – issue a boards command.
9.
Note: as firmware advances, the current flash code version will change. The data layout
may also be different from one version to another. The image below is using v4.60 s28.
10. Remove all config jacks from any 600 daughter boards. (635 boards do not have config jacks)
11. IF all boards show up as normal and match the CPU Flash Package (see chart above), then
press the reset switch on each daughter board.
12. After all the boards are up again, reissue the boards command in HyperTerminal.
Verify that all Board ID's are correct.
If any ID's are not correct you must return to Step 7 to program and save the board ID correctly. BE
SURE TO ALLOW ALL BOARDS TO COMPLETE FLASH UPDATES BEFORE POWER FAILING or
pressing the RESET switch.
600-SERIES HARDWARE MANUAL
APPENDIX-Page H-11