Galaxy Control Systems 635 Series Installation/Configuration Manual page 158

H – Appendix : Putty/HyperTerminal Commands
A. Connecting to a Terminal Emulator
Connect the programming serial cable to the J4 serial port of the CPU Board (Rev H or later)

and the standard 9-pin serial (com) port on the PC or laptop that will run Terminal Emulator.
A programming cable comes with the controller enclosure:
• The cable must have a DB9 female connector on one end and a DB9 male connector on the
other end.
Cable Pin-out
•
On the PC/Laptop, click the [START] button.

Browse the menu path to Programs>Accessories>Communications and select (click) the

HyperTerminal icon that looks like a telephone.
In the Connection Description box you need to type a name for the connection and click [OK]

Terminal Session parameters are:
Bits per Second = 57,600K
Parity = None
Data Bits = 8
Stop Bits = 1
Flow Control = None
See table of Putty/HyperTerminal commands on next page

600-SERIES HARDWARE MANUAL
Appendix H - HyperTerminal Commands
must be: Pin 2 to Pin 2, Pin 3 to Pin 3, Pin 5 to Pin 5.
APPENDIX-Page H-1
Note: When you close the Terminal, it will prompt you
to save the connection. You can save it and use it in
the future to connect to 600-series & 508i panels.