Possible Malfunctions - Bartscher MultiTherm A200050 Instruction Manual

o In the case of water containing lime, a calcareous layer, which can have an influence
on the heating power of the device appears in the container, particularly at the bottom
of it. It is possible to remove this residue carefully by adding to water a drop of vinegar
or a lime remover available on the market and by boiling this solution for a short time.
o After removing lime rinse the container with clean water.
o After cleaning you should apply a soft, dry cloth in order to wipe dry and polish the
surface.
CAUTION!
Complaints will not be accepted if the device is not decalcified regularly
as described in the instruction manual.
Such complaints are no cases of warranty!
Storage of the device
o If the device is not used for any lengthy period of time, clean it according to the
aforementioned description and store it in dry, clean place protected against cold,
sun and children. Do not place any have objects on the device.

7. Possible Malfunctions

In case of malfunction, disconnect the device from its power source. Before contacting
the service or sales agent, verify - based on the table below - whether it is possible to
eliminate disruption in operation.
Problem
Control lamp do not flash
up after switching into
temperature stage
Device does not work
If you cannot remove the malfunctions:
- do not open the body,
- notify the customer service point or contact the sales
agent, while providing the following information:

type of malfunction;

article and serial number (rating plate at the
rear of the device).
Please check:
 If power plug is plugged in properly
 If the socket works properly ((main) fuse and/or
residual current circuit breaker are OK)
 The protection against overheating will be
activated was released because of overheating
- 31 -