Bartscher MultiTherm A200050 Instruction Manual page 33


The temperature control is infinitely variable between approx. 30 °C - 90 °C.
NOTE!
The heat is created via a heating coil in the bottom part of the mulled wine pot.
The electric temperature control with the temperature sensor are placed here
as well. The adjustment of temperature is done via the thermostat switch.

Turn the temperature control with the red dot rightwards and set it to the desired
temperature (the orange control lamp flashes up). When the desired (set)
temperature is reached the orange control lamp switches off and the green control
lamp flashes up (warm keeping mode).
NOTE!
The heating time depends on the liquid and the amount. When the desired
liquid temperature is reached the thermostat shuts off automatically.
In case the liquid temperature drops below the desired temperature the
thermostat switches on to keep the liquid at the set temperature over a larger
period of time.

For tapping/drawing liquid turn the handle of the stop valve
to the front. After finishing the tapping of liquid turn back
the stop valve to its original position.

Conditional on the system a quantity of approx. 1 litres
remains in the container. This quantity can be slightly
reduced by carefully tilting the container forward.
HOT SURFACE! Burn hazard!
While operating the mulled wine pot the surface of the
container will be heated up according to the adjusted
temperature! Do not touch hot surface!

When the device is not in use, make sure you the temperature controller is turned all
the way to the left as far as it will go, pull the power plug out of the socket, let the
liquid drain and clean the container after it has cooled off.
- 29 -