Table of Contents
Advertisement
Available languages
Available languages
WARRANTY & SYSTEM INSTALLATION GUIDE
Specific Safety Information
Risk of electric shock. This
pump is supplied with a grounding-type plug. To
reduce risk of electric shock be certain that it
is connected only to a properly grounded, GFCI
receptacle.
For your own safety, before assembling and
operating this unit, read this operators manual
carefully and completely. Learn the operation,
application, and potential hazards peculiar to
this unit.
Call the Technical Service Department at (1-800-237-
0987) if you have any questions.
Utility Pump Safety
• Do not use to pump flammable or explosive fluids
such as gasoline, fuel oil, kerosene, solvents,
thinners, etc. Do not use in a flammable
and/or explosive atmosphere. Pump should
only be used to pump clear water. Improper
use could result in personal injury and/or
death.
• If there is water or moisture on the floor, do not walk
on wet area until all power is turned off. If the shut-
off box is in the basement, call an electrician. Failure
to follow this warning could result in fatal electrical
shock.
• Always disconnect the power source before
attempting to install, service, relocate, or maintain
the pump. Never handle a pump or pump motor
with wet hands or when standing on a wet or damp
surface or in water when the pump is connected to
power. Failure to follow this warning could result in
personal injury and/or death.
Description and Specifications
Description
The Submersible Utility Pump is designed for non-
automatic use in water. The unit is equipped with a
3-prong grounding type power cord. The motor is oil
filled and sealed for cooler operation. The discharge
fitting is designed for convenient attachment to a
garden hose.
2
• This pump is not designed to handle salt water,
brine, laundry discharge, or any other application
which may contain caustic chemicals and/or foreign
materials. This pump is not suitable for use with
aquatic life. Pump damage or failure could occur if
used in these applications and will void the warranty.
Specifications
Motor:
Rating . . . . . . . . . . . . . . . . .120V, Single Phase
Installation:
Pump Down Level . . . . . . . . . . . . . . . 1/8 inch
Liquid Temperature Range . . . . . . 40˚F to 120˚F
Discharge Size . . . . . . . . 3/4 inch Garden Hose
Pump Installation
• Pump should only be used to pump clear water. Do
not use to pump fluids such as gasoline, fuel oil, or
kerosene. Do not use in a flammable or explosive
atmosphere. Improper use could result in personal
injury and/or death.
To prevent property damage, serious injury, or
death, proper use of the pump is required. The
following procedures should be followed:
• Always disconnect the power source before
attempting to install, service, relocate, or
maintain the pump. Never handle a pump
or pump motor with wet hands or when
standing on wet or damp surface or in water
when pump is connected to power source.
1. This pump has been designed to attach to a
standard garden hose. Thread the female end of
the garden hose to the discharge on the pump.
2. To reduce leakage between the pump and the
hose, place a hose washer (not included) on the
garden hose before use to the pump.
3. For best pump performance, unwind the hose
before starting the pump. This will help remove
any kinks or binds in the hose and allow the unit to
pump with less restriction.
4. Place pump on a hard surface in the water. Do not
set the pump directly on mud or sand surfaces.
This will cause the inlet screen to clog.
www.waynepumps.com
Advertisement
Table of Contents
