Table of Contents
Advertisement
Operating Instructions and Parts Manual
SPECIFICATIONS
POWER SUPPLY REQUIREMENTS
MOTOR
HORSEPOWER
CIRCUIT REQUIREMENT
LIQUID TEMERATURE RANGE
CONSTRUCTION
MOTOR HOUSING
Thermoplastic
MOTOR SHAFT
Stainless Steel
IMPELLER
Thermoplastic
VOLUTE
Thermoplastic
PUMP DISCHARGE
3/4 in. Brass Hose Fitting
PERFORMANCE
Model
HP Discharge Head
TSC130
1/4
Gal / hr
© 2018, WAYNE/Scott Fetzer Company
120 V, 60 Hz
Single Phase
1/4
15 A (minimum)
40° F- 120° F
0 ft
5 ft
10 ft
15 ft
1250 1140 1000
830
Please read and save these instructions. Read carefully before attempting to assemble, install,
operate or maintain the product described. Protect yourself and others by observing all safety
information. Failure to comply with instructions could result in personal injury and/or property
damage! Retain instructions for future reference.
20 ft
640
www.waynepumps.com
DEWATERING PUMP TSC
620006-001 B 08/18
TSC130
Advertisement
Table of Contents
Related Manuals for Wayne TSC130
Summary of Contents for Wayne TSC130
- Page 1 VOLUTE Thermoplastic PUMP DISCHARGE 3/4 in. Brass Hose Fitting PERFORMANCE Model HP Discharge Head 0 ft 5 ft 10 ft 15 ft 20 ft TSC130 Gal / hr 1250 1140 1000 © 2018, WAYNE/Scott Fetzer Company www.waynepumps.com 620006-001 B 08/18...
-
Page 2: General Safety Information
Operating Instructions and Parts Manual DESCRIPTION GENERAL SAFETY INFORMATION The Submersible Multi-Use Pump is designed for non-automatic CALIFORNIA PROPOSITION 65 use in water. The unit is equipped with a 3-prong grounding type power cord. The motor is oil filled and sealed for cooler operation. The discharge fitting is designed for convenient attachment to a garden hose. -
Page 3: Electrical Safety
Operating Instructions and Parts Manual TSC130 ELECTRICAL SAFETY PERSONAL SAFETY This pump must be plugged into a properly installed, and grounded GFCI outlet in accordance with all applicable • Stay alert, watch what you are doing, codes and ordinances. Never remove the grounding prong or modify the and use common sense when using this plug in any way. -
Page 4: Pump Installation
Operating Instructions and Parts Manual SERVICE MULTI-USE PUMP SAFETY • Do not use to pump flammable or explosive fluids such • Pump service must be performed only by qualified as gasoline, fuel oil, kerosene, solvents, thinners, repair personnel. Service or maintenance performed by etc. -
Page 5: Maintenance Instructions
Operating Instructions and Parts Manual TSC130 PUMP INSTALLATION (CONT’D) 6. Plug the power cord into a grounded GFCI 120 volt AC power outlet. Make sure the electrical outlet is grounded and is rated for at least 15 amps. The pump will start •... -
Page 6: Troubleshooting Chart
Operating Instructions and Parts Manual MAINTENANCE INSTRUCTIONS (CONT’D) 1. Keep pump inlet clean and free of all foreign objects. Inspect inlet at beginning of each use. 2. The motor housing is permanently sealed and requires no service. Disassembly of the motor housing or alteration of the power cord could result in fatal electrical shock. - Page 7 For Replacement Parts or Customer Support, Call 1-800-237-0987 Please provide following information: Address parts correspondence to: - Model number WAYNE Water Systems - Serial number (if any) 101 Production Drive - Part description and number as shown in parts list Harrison, OH 45030 U.S.A.
-
Page 8: Limited Warranty
LIMITED WARRANTY For one year for TSC130 model from the date of purchase, from an authorized dealer, Wayne Water Systems will repair or replace, at its option for the original purchaser, any part or parts of its Multi-Use Pumps or Water Pumps (“Product”) found upon examination by Wayne Water Systems to be defective in materials or workmanship.