Maintenance Instructions; Service And Repair - Wayne TSC Series Quick Start Manual

Do not place pump directly on
clay, gravel, or any loose or sandy surfaces. These
surfaces contain small stones or sand that may clog
or damage the pump. This could result in pump failure
causing flooding and property damage.
5. The water level must be at least 1/2 inch for the
pump to operate. Water levels less than 1/2 inch
will not allow the impeller to contact water and no
water will be pumped.
6. Inspect the power cord and plug for damage. If the
plug is missing the grounding prong or the cord is
damaged, do not use the pump until the cord has
been replaced.
Never cut off grounding prong or
use an adapter.
7. Plug the power cord into a grounded 120-volt AC
power outlet. Make sure the electrical outlet is
grounded and is rated for at least 15 amps. The
pump will start operating as soon as the power
cord is plugged into the power outlet.
8. The pump will remove water down to 1/8 inch of
the surface the pump was placed on.
9. The pump should be unplugged once the water
has reached the 1/8 inch height, or pump will run
dry.
Do not allow pump to run dry.
The shaft seal depends on water for lubrication.
Operating the pump without water will damage the
shaft seal and cause pump failure.
When routing electrical cord protect cord from sharp
objects, hot surfaces, oils, and chemicals. Do not kink
cord; replace any damaged cord immediately.

Maintenance Instructions

Always disconnect the
electrical supply or unplug the pump before
attempting to install, service, relocate, or perform
any maintenance. If the power source is out of
sight, lock and tag in the open (OFF) position to
prevent unexpected power application. Failure
to do so could result in fatal electrical shock.
Only a qualified technician should repair this unit.
Improper repair could result in fatal electrical shock.
1. Keep pump inlet clean and free of all foreign
objects. Inspect inlet at beginning of each use.
2. The motor housing is completely sealed and
requires no service. Disassembly of the motor
housing or alteration of the power cord could result
in fatal electrical shock.

SERVICE AND REPAIR

pump must be performed by qualified repair personnel.
Pump should be taken to a Independent Authorized
Service Center or returned to the factory. All repairs
made by WAYNE service facilities are warranted against
defects in material and workmanship.
identical Ace replacement parts should be used.
Failure to follow these steps may create a risk of
flooding, property damage, fatal electrical shock, or
other serious injury.
www.waynepumps.com
WARRANTY & SYSTEM INSTALLATION GUIDE
Service and repair work on this
When servicing this pump, only
3