Table of Contents
Advertisement
EN
16
HOW TO HANDLE THIS PRODUCT
ATTENTION! Never insert your fi ngers in the hopper chute!
ATTENTION! Never use the equipment without the hopper!
ATTENTION! Do not lean over the hopper!
How to collect the shredded material
Before you move the bag closer or further, please shut off the drive unit.
To collect the material, you can use a collection bag (if supplied) or place the shredder on a canvas to
capture the shredded material.
If you use a collection bag, it's necessary to attach both bag hooks to the hopper chute.
ATTENTION! Don't cover the ventilation openings located on the machine body with a collection bag or
crushed material.
Knife replacement procedures (Fig. 8.)
Shut the shredder off and unplug it from the mains.
Loosen the knife plate cover release screw to remove the top of the hopper assembly.
The knives are both-sided. When the edge gets blunt, your can turn it upside down and use the other side.
It's recommended to wear gloves when replacing the knives.
To lock the shredding disc, please use an Allen wrench (c). Unscrew both internal hex nuts (b), paying
close attention to the knife cutting angle.
Remove the knife and turn it by 180 degrees (a); seat the edge on the disc so that the edge bottom section
points downwards.
Repeat the same procedure for the second knife.
If both knife edges get blunt, they should be replaced simultaneously. The edges can be sharpened
again. (The sharpening must be only done by a skilled professional). However, this solution is not much
recommended as it's vital for the correct machine functionality that the knives on the disk should be
absolutely balanced. A slightest imbalance may lead to machine damage or even operator injury.
Product care
ATTENTION! When performing maintenance and cleaning of the machine, make sure that it's unplugged
from the mains.
If you are about to perform a service inspection of the equipment, store the equipment or replace any of its
parts, turn off the drive and unplug the equipment.
If you use an extension cord, this should not be lighter than the equipment's own power cord.
Please check power cord and/or extension cord (if used) for possible signs of wear on regular basis. In the
event of damage, don't use the equipment.
When performing service jobs on the shredding mechanism, please note that the mechanism can be
started manually even if the motor is locked by the safety switch tripping.
Never disable the safety switch.
Please use brush to remove dirt deposits from the equipment.
FZD 4007-E
Advertisement
Table of Contents
