Mulching; Setting The Mowing Height; Replacing The Mowing Blades; Changing The Motor Oil - Fieldmann FZR 5124 BV Instructions For Use Manual

EN 12
Controlling and operating the lawnmower

MULCHING

Caution! Attach and remove the mulching plug only with the engine turned off.
Caution! Use only original mulching accessories when mulching.
1. Remove the grass catcher and hold the plastic grass catcher cover with your hand (Fig. 9 – point 1)
2. Install the mulching plug into the discharge chute
(Fig. 9 – point 2) and make sure that the plug is seated fi rmly.
IMPORTANT INFORMATION: Do not mulch tall
grass all at once, this will prevent overloading the
lawnmower mechanism and the engine.

SETTING THE MOWING HEIGHT

The mowing height is set centrally using the central mowing height adjustment lever (Fig. 1 – point 11). You can
select in the range of 25 to -80 mm. The middle mowing height is the most suitable for the majority of lawns.
Lawn damage may result when the lowest height is set.
Caution! For maximum effectiveness, please always trim the grass by 1/3 of its length only. Mow the
overgrown grass gradually and after each mowing, lower the height by one step. To keep quality lawn, do not
use the lowest mowing height setting.

REPLACING THE MOWING BLADES

Caution! Contact an authorised service centre.
If you wish to replace the mowing blade, remove the bolt (Fig. 10). Perform the installation according to the
provided picture. Tighten the screw. The tightening torque is 40 Nm. When replacing the blade, replace the
fastening bolt as well.

CHANGING THE MOTOR OIL

Caution! For this task, we recommend that you contact an authorised service centre.
The drain plug is located under the engine. Place a suitable container for catching the used oil under the engine
and remove the plug. Tilt the lawnmower so that all the oil can drain from the oil tank.
Fig. 10
FZR 5124 BV
Fig. 9