Mulching; Setting The Mowing Height; Replacing The Mowing Blades; Changing The Motor Oil - Fieldmann FZR 5125 B User Manual

EN 12 Controlling and operating the lawnmower

MULCHING

Caution! Attach and remove the mulching plug only with the engine turned off.
Caution! Use only original mulching accessories when mulching.
1. Remove the grass catcher and hold the plastic grass
catcher cover with your hand (Fig. 9 – point 1)
2. Install the mulching plug into the discharge chute
(Fig. 9 – point 2) and make sure that the plug is seated
fi rmly.
IMPORTANT INFORMATION: Do not mulch tall
grass all at once, this will prevent overloading the
lawnmower mechanism and the engine.

SETTING THE MOWING HEIGHT

The mowing height is set centrally using the central mowing height adjustment lever (Fig. 1 – point 9)
You can select from 5 positions in the range of 25 to 75 mm. The middle mowing height is the most suitable for
the majority of lawns.
Lawn damage may result when the lowest height is set.

REPLACING THE MOWING BLADES

Caution! For this task, we recommend that you contact an authorised service centre.
Caution! Prior to removing the blade, drain the oil from the oil tank.
If you wish to replace the mowing blade, remove the bolt (Fig. 10). Perform the installation according to the
provided picture. Tighten the screw. The tightening torque is 40 Nm. When replacing the the blade, replace the
fastening bolt also.

CHANGING THE MOTOR OIL

Caution! For this task, we recommend that you contact an authorised service centre.
Fig. 9
Fig. 10
FZR 5125 B