Nordson iTrax Quick Start Manual

Spray control and monitor system

Hide thumbs Also See for iTrax:

Download this manual

Prepare to Install

1. Turn off control unit.

2. Install the iTrax SM, SC, and PRx

modules using the included instructions.

3. Turn off power to the control unit that

houses the spray units.

Install the Network Wiring

1. Install the network wiring and included

terminating resistor into the DB-9

connector.

2. Assemble the connector halves.

3. Disconnect the softing network

interface from the USB until after the

softing drivers are installed.

iTrax Spray Control and Monitor System

Quick Start Guide

P/N 1604851-03

Follow the safety, operation, and

maintenance instructions in the

accompanying Operator Card

Comm B (blue)

Resistor

Comm A (white)

and Product Manual.

Shield

Part 1604851-03

Page 1 Operator Card and Product Manual. Prepare to Install 1. Turn off control unit. 2. Install the iTrax SM, SC, and PRx modules using the included instructions. 3. Turn off power to the control unit that houses the spray units.
Page 2 Wait for Windows to display the notification that the CAN driver has been installed successfully. Install the iTrax Software Install the software on the iTrax spray control and monitor system USB drive. Select both the iTrax OPC Server and CanWorks iTrax Local Client when prompted.
Page 3 Windows desktop. 2. Select Help icon from the main toolbar and select Display Help. Calibrate Spray Monitors When the coating system is producing acceptable product, calibrate the spray monitors and enable faults as needed. © 2018 Nordson Corporation Part 1604851-03...
Page 4 Video ....SVGA, 2 MB (minimum), 1024 X 768, 16-bit color www.nordson.com 800.626.8303 www.enordson.com http://emanuals.nordson.com www.nordson.com Issued 8/18 Original copyright date 2014. Encore, Nordson, and the Nordson logo are registered trademarks of Nordson Corporation. © 2018 Nordson Corporation Part 1604851-03...