Use this procedure to upload the current software onto a
®
new iTrax PC. To access the newest software, contact
ICS Technical Support at
Pre-Software Installation
Prepare to Install
1
1. Be sure all power to the control unit
containing all of the iTrax modules is OFF.
2. Install and wire the iTrax SM, SC, and
PRx modules using the included
instructions.
Install the Network Wiring
2
1. Install the network wiring and included
terminating resistor into the DB-9
connector.
2. Assemble the connector halves.
3. Disconnect the Softing Network
Interface from the USB until after the
Softing Drivers are installed.
Connect the other end of the network
3
wiring to the main terminal block in the
control unit.
Refer to your system drawing for specific
wiring instructions.
© 2019 Nordson Corporation
ics.tech.support@nordson.com
iTrax PC Replacement
®
.
Resistor
Comm A (white)
Quick Start Guide
P/N 1607389-02
Follow the safety, operation, and
maintenance instructions in the
accompanying Operator Card
and Product Manual.
Shield
Comm B (blue)
Part 1607389-02