Assembly Of The Attachment Pieces - Kessel INNO-CLEAN Technical Description, Installation, Operating And Maintenance Instructions

Wastewater loading system

4.9 Assembly of the attachment pieces

Lip seal DN 600
4. Installation and assembly
Air connection manifold
Air hose with compressor
Sludge transfer system
Telescopic attachment piece
Clamping ring
Tank dome
Minimum insertion
depth 100 mm
109
Clear water removal system
First of all, place the seal (see drawing 4.9) into the bead pro-
vided inside the dome.
Grease the bottom part of the telescopic KESSEL attachment
piece with lubricant and place into the tank opening, bring into
the desired position and fasten by means of a clamping ring.
Alternatively, it is also possible to apply lubricant to the sea-
ling ring. With the aid of the existing clamping ring it is now
possible to fasten the attachment piece in the desired positi-
on (alignment with the top ground surface). The fine adjust-
ment to the final height is then effected with the adjusting scr-
ews. A ground slope can be compensated for with the conti-
nuously height-adjustable and up to 5° inclinable attachment
piece. The "Innofant" labels included in the supply must be
attached to the cleaned and dry surface on
the attachment piece (see illustration).
Important: The green "Innofant" must be placed on the inlet
side and the red one on the drain side!
The attachment piece must afterwards be sufficiently backfil-
led and compacted.
Aeration tube