Frame Preparation - Cervélo ASPERO Assembly Manual

FRAME PREPARATION

1. Apply carbon assembly compound to both frame and seatpost.
2. Insert Seatpost Clamp fully onto frame seat tube chimney.
3. Adjust height and torque the lightly greased binder bolt to 6Nm maximum.
If trimming is required,
final length should allow
for a minimum of 70mm
of seatpost remaining in
the frame, or the minimum
insertion dimension indicated
on the seatpost, whichever
is greater. Failure to meet
this requirement, may result
in damage to the frame not
covered by warranty policy, or
serious injury to rider.
4. Insert frame into bike stand, clamping onto the seatpost.
4
Clamping the
top tube can
damage the
frame and void
your warranty.
5. Lightly grease Rear Derailleur Hanger Fixing Nut and install
Rear Derailleur Hanger finger tight. Final tightening will be
done after rear wheel installation.
6. Secure the Front Derailleur Mount (or Blanking Plate on
1x setups) into frame with two bolts. Tighten to 3Nm.
Do not final tighten
rear derailleur hanger
assembly without rear
wheel installed. Doing so
will result in a misaligned
derailleur and poor
shifting.