Frame & Fork Preparation - Cervélo PX Series Retailer Assembly Manual

FRAME & FORK PREPARATION
1. Apply carbon assembly compound to both
frame and seatpost.
2. Insert Seatpost Clamp (SPC-148A) in frame so
it is flush with the top tube.
3. Adjust height and torque to 8Nm maximum.
Hold the frame using a secured seatpost only.
Clamping the top tube can damage the frame
and void your warranty.
5
1. Lightly grease supplied M4 fixing screw.
Install the Threaded Fork Insert (QRI-THD)
and fixing screw, tightening only lightly.
2. Without wheel in place, install the axle
and tighten until the flange meets the fork
dropout face, but does not compress the
fork blades.
3. Tighten the fixing screw to 3Nm.
4. Remove the axle and install wheel.
Reinstall axle and tighten to 12-15Nm.
5. Remove axle and wheel, and re-torque the
fixing screw to 3Nm.
Install Front Derailleur Mount
(FDM-0E0), and ensure fixing
screws are torqued to 3Nm.
For 1x systems replace with
the Front Derailleur Mount
Blanking Plate (FDM-CVR).
Lightly grease Rear Derailleur Hanger
Fixing Nut and install Rear Derailleur
Hanger (DRH-WMN112) finger tight. Final
tightening will be performed after rear
wheel installation.
Do not final tighten rear derailleur hanger
assembly without rear wheel installed.
Doing so may result in a misaligned
derailleur and poor shifting.
Clean chainstay with isopropyl
alcohol and apply chainstay
protector.
6