Cervélo S5 Supplementary Manual
  1. Manuals
  2. Brands
  3. Cervélo Manuals
  4. Bicycle
  5. S5
  6. Supplementary manual

Cervélo S5 Supplementary Manual

Hide thumbs Also See for S5:

Advertisement

Table of Contents

See also: Owner's Manual , Supplementary Manual
S5 Supplementary manual
Cervélo S5 Supplementary Manual
1

Advertisement

Table of Contents
loading

Related Manuals for Cervélo S5

Summary of Contents for Cervélo S5

  • Page 1 S5 Supplementary manual Cervélo S5 Supplementary Manual...
  • Page 3 We hope you enjoy the S5 as much as we do.  Enjoy the ride and thanks for choosing Cervélo. NOTE: This manual is designed as a supplement to your Cervélo Owner’s Manual, and is specific to the unique features of the S5. It contains important installation and set-up information;...

  • Page 4: Table Of Contents

    4. Maintenance and Replacement Instructions ....20 A. Replaceable Derailleur Mounts ......20 Cervélo S5 Supplementary Manual...

  • Page 5: Features Diagram

    1. FEATURES DIAGRAM A Map To Your Cervélo S5 Drainage hole Single bend cable guide Front Derailleur cable hole Di2 battery cable hole Rear Derailleur cable hole Di2 Shift control cable hole Di2 battery holder mount Cervélo S5 Supplementary Manual...

  • Page 6: Assembly Instructions

    2. ASSEMbly INSTRUCTIONS A. Fork Installation Your Cervélo S5 uses a fork which has been engineered specifically to fit this bike and maximize performance. Please familiarize yourself with the complete Cervélo Fork Owner’s Manual supplied with the bike before proceeding with any installation or service.
  • Page 7 Allow 30 seconds for the alcohol to dry before proceeding. Cervélo S5 Supplementary Manual...
  • Page 8 Using gloves, the wooden mixing stick, and a clean disposable tube. If any rough edges are detected, have the components repaired surface; fully mix the epoxy in the kit supplied with the fork (sharp edges removed) or replaced before proceeding. Cervélo S5 Supplementary Manual...
  • Page 9 3T stem – follow manufacturer’s instructions if distance. other stem is used). When tightening, alternate between bolts after each full turn to ensure that torque is applied evenly to the fork steerer tube. Cervélo S5 Supplementary Manual...

  • Page 10: Seatpost Installation

    TIP: If required, to determine whether to use front or rear tapered and serrated to match the seatpost hole position, please consult the S5 geometry chart at Inner Cradle non-drive side port in the seatpost. www.cervelo.com, or speak with your Cervélo dealer who can These cannot be reversed without give you information on the best setup for your needs.
  • Page 11 • Ensure that portion of the S5 seatpost to be inserted into the • Once the correct height has been chosen, tighten the frame is coated with carbon assembly compound, and insert compression screw to a maximum of 8Nm. the post into the frame a minimum of 6.5cm up to a maximum of 10cm.

  • Page 12: Rear Brake Caliper Installation

    Note: If you have purchased your S5 as a complete bicycle, the rear • Return the seatpost to the tool, and clamp approximately 10cm brake caliper will have been pre-installed at the factory.

  • Page 13: Rear Brake Cable Installation

    D. Rear brake Cable Installation counterbore facing toward the caliper. Parts Required: • Cervélo S5 click-in cable stop for top tube • With the brake plate centred on • Brake cable and housing with appropriate ferrules the pivot bolt, tighten the brake •...
  • Page 14 TIP: If your brake does not • Install the Cervélo S5 click-in-cable provide an accessible centering housing stop by threading the cable tool, remove the brake from the through its small opening, and placing...

  • Page 15: Routing Derailleur Controls

    A key component of this system is the S5’s single- bend cable guide (see www.cervelo.com for more information). If you choose to use an electronic shifting system, the S5 has been designed to accommodate the most efficient internal routing methods without sacrificing frame integrity, or aerodynamics.
  • Page 16 • Ensure that the front two cable holes (FD and RD) in the top tube Front Derailleur). The S5 was designed to have the lowest contain a pink-coloured plastic liner prior to cable installation. amount of cable friction with this length of housing.
  • Page 17 FD. drive-side chainstay. • Draw cable through opening as far as possible and leave until Step 4. Do not attach the cable to the FD at this time. Cervélo S5 Supplementary Manual...
  • Page 18 • Lift the shift cables off of the cable port bridge, and slide the S5 plastic cable guide underneath them while ensuring that the deeper cable track is oriented toward the drive-side.

  • Page 19: Fine-Tuning Instructions

    3. FINE-TUNING INSTRUCTIONS A. Installing Water bottle Cages • The S5 was designed to offer the best possible aerodynamics on a road bicycle, while remaining customizable to the rider’s specific hydration requirements. As STEP 5 traditional bottle designs are •...

  • Page 20: Maintenance And Replacement Instructions

    Loctite 242 (blue) threadlock on the bolt threads as per the A. Replaceable Derailleur Mounts manufacturer’s instructions. Your S5 utilizes replaceable front and rear derailleur mounts for • Reinstall the front derailleur mount by aligning the bolt holes simplified service and extended frame life. In the unfortunate over the inserts in the seat tube.
  • Page 21 Reinstall the wheel in the frame, and use a derailleur hanger alignment gauge to check that the Hanger is square relative to the wheel. If you have any questions about your S5 or for further assistance, please contact Cervélo Customer Service or your authorized Cervélo retailer. Cervélo S5 Supplementary Manual...

Table of Contents