Cervélo S5 Supplementary Manual
Hide thumbs
Also See for S5:
- Supplementary manual (59 pages) ,
- User manual (38 pages) ,
- Assembly manual (38 pages)
Advertisement
Advertisement
Related Manuals for Cervélo S5
Summary of Contents for Cervélo S5
- Page 1 S5 SUPPLEMENTARY MANUAL...
-
Page 2: Table Of Contents
This document has been prepared to guide you through the set-up of the unique features of the S5, but is intended only as a supplement to the assembly instructions offered by your component manufacturer. -
Page 3: Features Diagram
FEATURES DIAGRAM A guide to your Cervélo S5 Rear dropout cable exit Top tube internal cable ports Electric front derailleur wire exit hole Multi-position Downtube Mechanical front derailleur bottle mounts. cable exit hole Single bend cable guide External battery mount hole... -
Page 4: Getting Started
Derailleur cables Designed to accommodate electronic, mechanical and hydraulic controls, the S5 frame has been engineered to provide seamless integration of all shifting systems, regardless of method or brand. In order to do so, you will require the parts shown on the following page:... - Page 5 Hydraulic hose click-in guide (CBS-TTC-TT-HYDR) Mechanical shifting and brake click-in cable stops (CBS-TTC—TT-MECH) Reduced friction cable guide (BBG-R-2013) Top tube Rubber blanking Top tube cable stop plug for battery wire hole (ICS4-S5D) (GR-TTFILL-S5D) Rubber electric wire guide for rear dropout (GR-DROPOUT-GUIDE) Press-In cable stop for rear dropout...
- Page 6 Mechanical Front and rear derailleur cables should be assembled with the rear housing inserted into the drive-side port of the top tube cable stop, and the front housing in the non-drive side cable port (with rocket-adjuster installed). The housing should be long enough that it passed in a smooth arc from the lower back of the bar, over the stem cap, and enters the top tube cable stop perpendicular to the top tube.
- Page 7 Route cables through BB guide. Front cable crosses the valley. Route cables out of front derailleur and rear Feed cables in direction of seat tube and chain stay. dropout exit holes. Snap BB guide into frame. Install chain stay housing stop. Housing stop is about 8cm farther back, so use about 8cm shorter housing than normal.
- Page 8 Electrical These instructions and pictures are for assembling the Shimano and Campagnolo electronic shifting systems on the Cervélo S5, and are intended as a supplement to the manufacturer’s installation instructions only. Please refer to www.shimano.com, www.campagnolo.com and www.cervelo.com for additional information.
- Page 9 Insert rubber parts as shown. Shimano internal battery Close bottom bracket with the Cervélo cover.
-
Page 10: Rear Brake
REAR BRAKE The installation of the rear brake requires the attachment of the S5 brake plate to the caliper, before it can be fitted to the frame. Install caliper to S5 brake plate (size specific) using Install front click-in cable housing stop. -
Page 11: Replaceable Rear Derailleur Mount
REPLACEABLE REAR DERAILLEUR MOUNT Your S5 utilizes a replaceable rear derailleur mount (DRH-R-2012) for simplified service and extended frame life. In the unfortunate event that replacement is required, Cervélo recommends authentic Cervélo replacement parts be used. Inspect the frame for damage and ensure the frame is clear of any debris. Apply Loctite 242 to the fixing screws, and tighten the screws equally to a maximum of 2.5Nm. - Page 12 www.cervelo.com...