1. Manuals
  2. Brands
  3. Da-Lite Manuals
  4. Projection Screen
  5. TENSIONED ADVANTAGE ELECTROL
  6. Instruction book

Da-Lite Tensioned Advantage Electrol Instruction Book

Hide thumbs Also See for Tensioned Advantage Electrol:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Instruction Book For
Tensioned Advantage
Electrol
The
POWER
In
PRESENTATION PRODUCTS
DA-LITE SCREEN COMPANY, INC.
3100 North Detroit Street
Post Office Box 137
Warsaw, Indiana 46581-0137
Phone: 219/267-8101
800-622-3737
Fax: 219/267-7804
http:// www.da-lite.com
e-mail: info@da-lite.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Tensioned Advantage Electrol and is the answer not in the manual?

Questions and answers

Related Manuals for Da-Lite Tensioned Advantage Electrol

Summary of Contents for Da-Lite Tensioned Advantage Electrol

  • Page 1 Instruction Book For Tensioned Advantage Electrol POWER PRESENTATION PRODUCTS DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 219/267-8101 800-622-3737 Fax: 219/267-7804 http:// www.da-lite.com e-mail: info@da-lite.com...
  • Page 2 IMPORTANT SAFETY INSTRUCTIONS When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3.
  • Page 3 Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: NOTE: Use a screw driver or 5/32” Allen wrench to make adjustments.
  • Page 4 ADVANTAGE ELECTROL INSTALLATION JUNCTION BOX MOUNTED 120V WIRING DIAGRAM EXTERNALLY ON SCREEN CASE WHITE BLACK MOTOR GREEN IN MULTIPLE CONTROL INSTALLATIONS THE SWITCH IS REPLACED BY THE LOW VOLTAGE CONTROL, OPERATED FROM PUSH BUTTON STATIONS. SPDT SWITCH AC (COMMON) WITH CENTER OFF NOTE: A SINGLE SWITCH CANNOT BE USED TO OPERATE AC HOT MORE THAN ONE SCREEN.
  • Page 5 ADVANTAGE ELECTROL INSTALLATION VARIABLE POSITION MOUNTING BRACKET MOTOR POWER ENDCAP CONNECTOR MOUNTING FLANGE MOTOR END AUDIENCE ELECTRICAL SIDE JUNCTION BOX ACCESS DOOR 8" 6-13/16" 4-7/8" 3/8" THREADED ROD ATTACHED TO HANGER BRACKET NOT SUPPLIED 3/8" THREADED ROD ATTACHED TO ENDCAP FLANGE 6-3/8"...
  • Page 6 TROUBLESHOOTING SYMPTOM CAUSE SOLUTION 1. Screen will not operate or will not (a) Blown fuse. (a) Replace fuse. go “down.” Motor does not hum. (b) Tripped circuit breaker. (b) Reset circuit. (c) No power to operating switch or (c) Check above. Tighten all loose junction box.
  • Page 7 TROUBLESHOOTING SYMPTOM CAUSE SOLUTION 3. Screen does not stop at correct (a) Limit switch out of adjustment. (a) See Screen Adjustment section. position. 4. Noise. (a) Squeaking, rubber end plug (a) Center roller in case. rubbing on motor. NOTE: Screen will operate with a low-pitched hum.
  • Page 8 Da-Lite personnel. Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise. Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.

Table of Contents