Screen Adjustment - Da-Lite Tensioned Advantage Electrol Instruction Book

SCREEN ADJUSTMENT

Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly
adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner:
NOTE: Use a screw driver or 5/32" Allen wrench to make adjustments.
MORE SCREEN DROP
1. Place operating switch in "down" position.
2. When the screen stops, turn the "down" limit knob No. 1 (Fig.2) one turn counterclockwise. Test by raising picture
surface approximately two feet, then lower again. Repeat until desired picture surface position is attained.
LESS SCREEN DROP
1. Raise picture surface approximately two feet above desired level.
2. Place operating switch in "off" position.
3. Turn the "down" limit knob No. 1 (Fig. 2) one turn clockwise. Test by raising picture surface approximately two feet,
then lower again. Repeat until desired picture surface position is attained.
WHITE ADJUSTMENT
KNOB "DOWN"
REMOVE 2 SCREWS TO REMOVE
ACCESS DOOR
FIGURE 1
MOTOR POWER
CONNECTOR
MOTOR
SET SCREWS
MOTOR MOUNT
BRACKET
YELLOW ADJUSTMENT
KNOB "UP"
REMOVE 2 SCREWS TO OPEN JUNCTION BOX
PIN END BRACKET
2
SET SCREWS
FIGURE 2