Table of Contents
Advertisement
Introduction
System Connections
The following diagrams provides an overview of the connections that are required for the Director
system. Before handling the system's cables and components, make sure that the main power
plug is unplugged from any power source. For simplicity the Network connections are not shown in
the diagram below. See G
connecting network cables to the Director.
Rear Interface Panel
1.
TANDBERG 6000 Codec.
2.
PC VGA IN: Personal Computer Video Input, supports VGA, SVGA, and XGA resolution (15
pin female HD D-sub connector). See TANDBERG 6000 U
regarding codec I/O.
3.
DISPLAY VGA OUT: System Display VGA out, XGA resolution (15 pin female HD D-sub
connector).
4.
AUX CTRL 1: Bi-directional RS232 (9600,N, 8,1) (9 pin female D-sub connector).
5.
AUX CTRL 2: Bi-directional RS232 (9600,N, 8,1) supports SMART Board
Control Module (9 pin female D-sub connector).
6.
AUX CTRL 3: Bi-directional RS232 (9600,N, 8,1) used for PC com port with SMART Board
Software Package (9 pin female D-sub connector).
7.
PROGRAM: Bi-directional RS232 (115200,N, 8,1) used for diagnostics and loading software
to Director Module. (9 pin female D-sub connector).
8.
LAN DIAGNOSTICS: Ethernet port used for upgrading and troubleshooting the control
system (RJ45 connector).
9.
AC Input: Fused 120VAC (or 220VAC for Europe) Input.
10.
TOUCHPANEL: Supports Optional Touch sensitive panel (25pin female D-sub connector).
11.
TOUCHSCREEN/MOUSE: Supports SMART Board
compatible mouse (9 pin female D-sub connector).
12.
CRESNET: Port reserved for future expansion of Cresnet devices (15 pin male D-sub
connector).
12
S
> C
ETTING
TARTED
ODEC
TANDBERG Director Videoconferencing System
B
> N
ASICS
ETWORK AND
'
M
SER
S
ANUAL
TM
3000i touch overlay or Microsoft
LAN S
for
ETTINGS
for more information
TM
3000i Room
TM
Advertisement
Table of Contents
