Table of Contents
Advertisement
SystemSoft CardSoft 3.1 & FFS Installation Guide
1. Install all cables to your PC/104 PCMCIA Module
2. Insert CardSoft 3.1 and FFS diskette into your floppy disk drive.
Type install
3. Insure that your config.sys file appears as follows:
DEVICE = C:\DOS\SETVER.EXE
DEVICE = C:\DOS\HIMEM.SYS
DOS = HIGH, UMB
DEVICE = C:\CARDSOFT\SSVADEM.EXE
DEVICE = C:\CARDSOFT\CS.EXE
DEVICE = C:\CARDSOFT\CSALLOC.EXE
DEVICE = C:\CARDSOFT\ATADRV.EXE
DEVICE = C:\CARDSOFT\MTAA.EXE
DEVICE = C:\CARDSOFT\MTAB.EXE
DEVICE = C:\CARDSOFT\MTI1.EXE
DEVICE = C:\CARDSOFT\MTI2P.EXE
DEVICE = C:\CARDSOFT\MTSRAM.EXE
DEVICE = C:\CARDSOFT\MTDDRV.EXE
DEVICE = C:\CARDSOFT\SSMFLSH.SYS
DEVICE = C:\CARDSOFT\CARDID.EXE
Install original DOS software to insure proper operation
4. Note the following details regarding memory card installation
(where IDE HDD = C):
a. SRAM cards are bootable, readable and writeable. Drive
letter assignments are first slot F and second slot G
b. Flash cards are readable, writeable but not bootable. Drive
letter assignments are first slot F, second slot G. Format your
Flash card before initial reading/writing by executing
MCFORMAT.EXE.
c. ATA HDD/ATA Flash cards are bootable, readable and
writeable. Drive letter assignments are first slot D, second
slot E.
Note
SOFTWARE INSTALLATION
(
)
TYPE BY YOURSELF
(
)
TYPE BY YOURSELF
(
)
TYPE BY YOURSELF
3-3
Advertisement
Table of Contents
