Picture And Picture Input - Barco MDSC-8255 User Manual

Advanced operation
The failover input will be activated within about 7 seconds after the main source has been lost.
During the transition from main to failover input and vice versa, a text message is visible to inform
the user.
The main source can be changed while the failover input remains unchanged. During the selection
and synchronization of a new main source the failover function is temporary (7 sec) disabled.
To select the failover input
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the Failover Input submenu.
4. Select one of the available failover inputs and confirm.

5.3.5 Picture and Picture input

About Picture and Picture input
This function allows the display to show a second input source on the left side of the display. The Primary input
(main source) is still displayed on the right half of the screen.
The possible Picture and Picture combinations between the Primary input (main source) and the Secondary
input (PaP image) is displayed in the following table.
Primary input
DP 1.1
HDMI 2.0–1
HDMI 2.0–2
DVI
SDI
Both primary and secondary input are limited to FHD resolution max.
The Video Parameters applied to the Primary input Source are also applied to the Secondary input.
The 2nd source keeps the same image size (Native/Aspect) as the Primary input Source.
To select Picture and Picture input
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the PaP Input submenu.
4. Select one of the available PaP sources (or NONE) and confirm.
36 K5902133 (451920612483)-02
Secondary input
• HDMI 2.0–1
• HDMI 2.0–2
• DVI
• SDI
• DP 1.1 / Dual
• DVI
• SDI
• DP 1.1 / Dual
• HDMI 2.0–1
• HDMI 2.0–2
MDSC-8255