Installation - ADJ 32 HEX PANEL IP User Instructions

32 Hex Panel IP/32 Hex Panel IP Pearl
The 32 Hex Panel IP is fully operational in three different mounting positions; hanging upside-down,
mounted sideways on trussing, or set on a flat level surface. Be sure this fixture is kept at least 12m
(40ft) away from any flammable materials (decoration etc.). ALWAYS use and install the supplied
safety cable as a safety measure to prevent accidental damage and/or injury in the event the clamp
fails.
Screw one clamp via a M12 screw and nut into the Omega holder. Insert the quick-lock fasteners of
the Omega holder into the respective holes of the adjustable mounting bracket. Tighten the quick-
lock fasteners fully clockwise. Pull the safety-cable through the openings located on the rear of the
unit and over the trussing system or a safe fixation spot. Insert the end in the carabine and tighten
the safety screw.
Always ensure that the unit is firmly fixed to avoid vibration and slipping while operating. Always
ensure that the structure to which you are attaching the unit is secure and is able to support a weight
of 10 times the unit's weight. ALWAYS use safety cables that can hold 12 times the weight of the
unit when installing the fixture.
This equipment must be installed by a professional, and it must be installed in a place where it is out
of the reach of people's grasp.
Ensure ALL connections and end caps are properly sealed with a non-conductive dielectric
grease (available at most electrical suppliers) to prevent water ingress/condensation and/or
corrosion.
ADJ Products, LLC - www.adj.com - 32 Hex Panel IP/32 Hex Panel IP Pearl User Manual Page 8
OPTIONAL CLAMP (Not Included)
1
2 ADJUSTABLE MOUNTING BRACKET
OPTIONAL OMEGA BRACKET (Not Included)
3

Installation